Haven't backed any projects yet!
Hey folks,it's been a while since the last update but I am still on this project and many things have happened during the last months. After spending so much time and energy in this project, I fina...
After trying to sleep with the setup tonight and continuously fixing the position of the electrodes (in particular the reference) due to the incredible heat in my flat, I finally gave up. Today I w...
Hey folks,the last weeks have been very tough. However, my new flat and workspace are furnished and I now can go back to work again without unnecessary distractions. Although I currently have to wr...
Hey Dreamers, after the last labnote, only a few things happened. I had tested the openBCI device with several versions of my dry electrodes and failed multiple times, the best results were deliver...
Hey guys!Just a short labnote for you: all new upgrades have arrived and were mounted, the machines were calibrated and run totally perfect. The designs are nearly finished, now everything will be ...
Hey folks!It has been a while since the last labnote and many things happened during the last months – all of them can be summarized in one word: underestimation. If there is one thing that we have...
Hey folks!It has been a while since we have posted the last labnote and many things happened during this time. The good news: we could finally start doing the important work instead of continuously...
Needle in a haystackHey guys!After weeks of struggling around, tons of testprints and enormous expenditure of time, we found out what most likely causes the problems in our prints. We talked to man...
3D-Printing is madnessHi folks!Last week we received a new update from multec and were able to rebuild the printer. With the new printerhead and updates, the printer should finally do the things fo...